Screenshot 4: Connecting Kerio Control Box NG511 to the network To configure the appliance: 1. Connect the Internet port to the Internet (e.g.DSL or Cable modem) using an Ethernet cable. 2. Connect the LAN port to the computer that will be used to configure the appliance (see the figures above). 3. Turn on the appliance. I have tried to setup three more port forward rules with the same problem. I also have the same issue with the VPN and the Kerio Control Web access, that all used to work. Both VPN and Kerio Control Web admin have rules from Soure Internet Interfaces , Destination Firewall and services Kerio VPN/IP Sec and Kerio control WebAdmin. To log in, enter the DNS name of the computer with Kerio Operator: kerio.operator.name/admin; Administration runs solely via the HTTPS protocol on port 4021. The address is automatically redirected to: 6. Open a web browser and connect to the Kerio Control Administration web interface using either of the following URLs: Kerio Control – کریو کنترل یکی از ساده ترین و در عین حال قدرتمند ترین راه حل های امنیتی حفاظت از شبکه در برابر ویروس ها، کرم ها و دیگر نرم افزارها و فعالیت های مخرب است. این نرم افزار با دارا بودن بهترین طراحی شبکه، سازمان یا Start Outlook. Click on the Tools Menu and then Email Accounts. Select " Add a new directory or address book " and click " Next ." Select " Internet Directory (LDAP) " and click " Next ." Type the IP address or the domain name of the Kerio Connect server in the " Server Name: " field. Check the box " This server requires me to log on ." Q5ta. During the Kerio Control Installation. Follow these steps: When installing the new Kerio Control appliance, the last installation dialog shares a link to MyKerio, as seen below. Copy this link. Note: If you miss the link during the installation, you can add Kerio Control to MyKerio later Using the Kerio Control Administration console, as In Kerio Control's administration interface, click on the Configuration icon. Click Domains and User Login. Under the Authentication Options tab, in the Automatic logout section, select Automatically logout users if they are inactive. In the Timeout field, specify your preferred timeout interval. Click Apply. I have tried to setup three more port forward rules with the same problem. I also have the same issue with the VPN and the Kerio Control Web access, that all used to work. Both VPN and Kerio Control Web admin have rules from Soure Internet Interfaces , Destination Firewall and services Kerio VPN/IP Sec and Kerio control WebAdmin. The required port must not collide with any existing mapped port or any traffic rule allowing access to the firewall from the Internet. Otherwise, the UPnP port mapping request will be denied. Configuring the UPnP support. In the administration interface, go to Security Settings > Zero-configuration Networking; Click Enable UPnP service. To change the automatic pre-conguration, go to Kerio Control Administration to section Inter-faces. Formoreinformation,readConguringnetworkinterfaces . 2 The power button will turn green. Wait for 2-5 mins so the password reset procedure is executed. Turn off the hardware box. Unplug the USB drive. Turn on the hardware box. When the Kerio Control Engine starts up, open the administration interface in a browser. In the activation wizard, create a new password for the admin account.

kerio control web admin port